螺杆清洗剂

Screw-thread Cleaner (Solution)

特色：节省转色时间及胶料、清洁炭渍及保护螺杆，使用方便。

使用说明：

1、用清洗剂喷湿约5次要注射的塑料（4安机以下）

2、用手套或胶袋混和。

3、储料后 1至2分钟，才把塑料射出（重复以上程序，勿连续射出）

4、将料斗清洁干净，加入转色后所用新塑料，将之前余料射出后即可正常注塑。

注意：勿让儿童取玩。如不慎入眼，应立即以清水冲洗。

Screw-thread Cleaner (Solution)

特色：

Characteristics: Timesaver for changing plastic color , convenience for cleaning and protecting the screw.

用法：

Direction: 

1 . Use the cleaner to penetrate the plastic mold for 5 times.

2.Mix and blend with gloves.

3.Do not launch the plastic until one or two minutes after storage. (repeat the above process, avoiding launching continuously) 

4.Add the new plastic after cleaning the funnel, continue the new injection molding process after the remaining plastic injected.    

注意：

Caution: Keep away from children. If accidentally spray to eyes, rise with water and consult with the doctor immediately.

——

产品规格：

瓶装：单支150ML、500ML   12支/箱